Download 3devo DevoVision Beta

Using DevoVision on Windows 8 and below is just a matter of downloading and running the application with only minimal installation needed. Want to get started? Follow the steps below.

To get started right away, follow these steps.

1. Download the application below. The version should match the installed variant of Windows (32-bit or 64-bit). On recent hardware you almost certainly need the 64-bit version, but you can check using these instructions
2. Extract the zipfile you downloaded. Inside you will find the actual application along with the driver files and some additional documentation. Extract these into some convenient location where you will find them again.
3. Install the driver by right-clicking the file called 3devo-driver.inf in the driver subfolder and selecting Install.You might be asked to allow changes to your computer, if so, allow that. No further confirmation is shown, but if the driver is succesfully installed, a popup should appear in the lower right saying “Next 1.0 filament extruder (COM..) installed” when your machine is first plugged into the USB port.If you previously used 3devoUpdate to update your machine firmware, or are upgrading from an older version of DevoVision, the driver is already installed on your system and you can skip this step.
4. Start the application by double-clicking the application file (with the ‘3d’ icon).

Once started, the application can be accessed through the system tray in the bottom right and the main interface will open automatically in a browser window.

Make sure to reference the DevoVision manual page page to get a flying start with DevoVision.